![]() Below 15☌ the heater turns on as it is expected. After some reading I realized that this is the normal operation of the Eberspächer heater in in an Audi once the temperature is above 15☌. Don’t forget to disable the pin request of the sim card!At first I set the module to default and the error control to 0, that sets the permitted numbers of errors to 0.Afterwards I tried the to start the heater via sms and I firstly was surprised because only the ventilation started. Must be replaced by a genuine Webasto spare part ten years after it is used for. Now you can just set up the module as described in the manual. Of the risk of poisoning and asphyxiation, even if a timer or Telestart remote is. In the Audi A4 it is the ECU 18 where you have to change bit 6 of byte 1 and bit 0 of byte 2. In difference to a car that is already equipped with a remote control you need to adjust the heaters ECU. GND and 12V is to be connected and you are ready to go. It is connected directly to the cooling system, and therefore can function as a preheating heater. In that case you have to connect the blue wire of the Altox module directly to pin 6 of the plug of the heater. 'Webasto' is an autonomousA heater that is capable of running with the engine off. The heater is located beyond the right front wing. If you want the use the origin AUDI remote control in parallel you can do this also, but you have to use a relay in between that separates the signals of the origin AUDI remote control and the Altox heater because otherwise the Audi remote control and the Altox module would interfere.If your Audi is not equipped with a remote control you can also revamp your heater with the Altox module. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |